gumball boop

Description

Boop! Out Comes a 1″ Round Gumball!
Made with FOOD SAFE materials. 

Suggestion

40 1″ Round Gumballs
Ideal for smooth shell gumballs

Caution

Allergen: Contains Latex Rubber Bands 
Wrapper is a suffocation hazard. Small parts are a choking hazard. Avoid paper cuts and poking the sharp corners. 

Buy as a Sheet for $1

Basically pluck out, fold, and assemble. Decorate optional. No glue nor tape required. 

Not Included

Gumballs nor physical decor.

User Submitted Images

Decor Download

ASSEMBLY

Assembly coming this week.

Attention!

Step 1

Cardboard bends easily. Best to bend at bend lines. Follow the instructions for best assembly. 

Step 2

Rip the wrapper at the edge of the cardboard without lifting the cardboard. Remove wrapper. 

Step 3

Remove window and tape. 

Step 4

Remove rubber bands

Step 5

With one hand under the cardboard, using fingers, push up along the edge of the part while the other hand or thumb holds the top or pushes the top down. 

Step 6

Remove the small pieces. See yellow highlight for areas to remove. 

Step 7

Bend at the 8 bend lines. Always bend close to edge of bend line as possible. 

Step 8

Bend at the 4 bend lines. Always bend close to edge of bend line as possible. 

Step 9

Fold and insert two tabs into two slots until tabs are flush to bottom. Press top edge down to help push the tabs into slots. 

Step 10

Bend at the 2 bend lines. Insert tabs as shown. 

Step 11

Bend at the 3 bend lines. Bend close to the edge. 

Step 12

Bend at the  bend lines. Bend close to the edge. 

Step 13

Fold and insert tabs into slots. Repeat Step 13 for the other side. 

Step 14

Fold the flaps and insert tabs into their slots. 

Step 15

Stretch rubber band and place on flaps. 

Step 16

Fold and insert tabs into slots. 

Step 17

Fold and insert as shown. Make sure top and bottom are flushed. Open side walls as shown. 

Step 18

Place the rubber band on the tabs as shown. 

Step 19

Insert. Pinch the nose to allow it to slide through hole. Make sure the base is pressed down. At this point, don’t worry about testing if the nose will slide, because the bottom base isn’t held down at this point. 

Step 20

Bend at the 3 bend lines as shown and insert. 

Step 21

Bend at the 9 bend lines.

Step 22

Fold and insert tabs as shown. 

Step 23

Bend the window at the 4 bend lines. Bend in the direction where it is angled. 

Step 24

Wrap the window around ramp wall. Make sure the small cut is facing to your right on the ramp wall. Insert. 

Step 25

Fold front flap. 

Step 26

Bend at the 6 bend lines. Bend close to edge as possible. 

Step 27

Bend at the 4 bend lines. Bend close to edge as possible. 

Step 28

Bend at the 2 bend lines. Bend close to edge as possible. 

Step 29

Fold and insert tabs into slots. Repeat this step for the other side. 

Step 30

Gently squeeze back end flap and insert top lid as shown. 

Step 31

Congratulations! Fill up your Gumball Boop and Enjoy!